Audi Q5 Owners & Service Manuals

Audi Q5: Hood, Lids

READ NEXT:

 Overview - Hood

1 - Hood A second technician is needed to support and hold the hood during removal and installation. Removing: Remove the gas-filled strut from the hood. Refer to → Chapter "

 Hood, Adjusting

Special tools and workshop equipment required Gauge - Gap Adjustment -3371- Hood Gap Dimensions Dimension -A- = 5.0 mm Dimension -B- = 4.5 mm Dimension -C-= 5.0 mm Dimension -D- = 3.0 mm Di

 Overview - Rear Lid

1 - Gas-Filled Strut Noise insulation component must be installed on the body side. 2 - Rear Lid Hinge Removing. Refer to → Chapter "Hinges, Removing and Installing".

SEE MORE:

 Setting the distance

Applies to vehicles: with Audi adaptive cruise control Fig. 124 Selector lever: setting the distance Tap the switch to display the current set distance > fig. 124. To increase or reduce the distance by increments, tap the switch again to the left or right. The distance between the two vehic

 Power Steering Fluid Level, Checking

- Do not run engine and turn front wheels to straight ahead position. Fluid cold (approximately 20 ºC (68 ºF) ): - Remove the cap. - Wipe dipstick off with a clean cloth. - Screw cap on hand-tight and unscrew again.   Note The cap must be fully screwed in order to obtain

© 2019-2026 Copyright www.audiq5.net