Audi Q5: Bumpers
READ NEXT:
Overview - Bumper Cover, One-Piece Version, Audi Q5
1 - Bolt
2.5 Nm
Quantity: 4
2 - Bolt
5 Nm
Quantity: 4
3 - Bumper Cover End Plate
Removing and installing. R
Removing
Version 1:
- Remove the clamping pins from the expanding clips
-2-.
- Remove the expanding clips.
- Lift the lock carrier cover -1-
and pull it off the radiator grille -4-.
V
Air Intake Grille, Removing and Installing, Audi Q5
Removing
Version 1:
- Remove the air intake grille -2-
from the bumper cover -1-.
Version 2:
- Release the hook -arrow A-
using a screw
SEE MORE:
Special tools and workshop equipment
required
Torque Wrench 1331 5-50Nm -VAG1331-
WARNING
Note the following before removing the steering
column:
Create a sketch showing the:
routing of the electrical wiring harnesses
securing of the electrical wiring harnesses
cable tie locations.
The flange/driveshaft used before must be installed.
If the flange/driveshaft is also being replaced, do the
following. Refer to
→ Chapter "Flange Shaft Ring, Replacing, 0BD".
Special tools and workshop equipment
required
Puller - Multiple Use -VW391-
Slide Hammer Set -VW771-
Slide
