Audi Q5: Windshield/headlight washer container
Fig. 203 Engine compartment: cover on the windshield
and headlight washer fluid reservoir
The washer fluid container is marked with the
symbol on its cap > fig. 203, > fig.
197.
You can find the reservoir capacity in the table.
Clean water should be used when filling up. If
possible, use soft water to prevent scaling on the
washer jets. Always add a glass cleaner solution
(with frost protection in the winter).
Note
Do not mix engine coolant antifreeze or any
other additives to fill up the windshield washer
reservoir.
READ NEXT:
General information
Check your tires regularly for
damage (punctures, cuts, cracks
and bulges). Remove foreign objects
from the tire tread.
If driving over curbs or similar
obstacles, drive slo
Fig. 204 Tire designations on the sidewall
Tires for passenger vehicles (if applicable)
P indicates a tire for a passenger vehicle. T indicates a tire
designated for temporary use.
Nominal widt
SEE MORE:
- Setup requirements.
- Connect the Vehicle Diagnostic Tester.
Calibration Tool - Wheel Center Mountings -VAS6350/1-
installing:
- Check which hole circle the rims have.
- Mount the Calibration Tool - Wheel Center Mountings
-VAS6350/1- appropriately.
- To do so, attach th
1 - Hood
A second technician is needed to support and hold the hood during
removal and installation.
Removing:
Remove the gas-filled strut from the hood. Refer to
→ Chapter "Overview - Gas-Filled Strut".
Remove the nuts -4- from the upper hood
hinge.
Remove the hood.