Audi Q5: Telephone System
READ NEXT:
The telephone system consists of the following components:
Cell phone preparation (CAN)
The CAN Bus connects the Telephone Transceiver -R36- to the
Infotainment system (radio). It also has a Bluet
The Microphone Unit In Front Roof Module -R164- in installed
in the Front Interior Lamp -W1-. Depending on the equipment,
there are up to three microphones installed.
One microphone (Interior Microp
Telephone Baseplate -R126-, Removing and Installing, Cradle
- Turn off the ignition and all electrical consumers and
remove the ignition key.
WARNING
Danger of unintended engine ignitio
SEE MORE:
1 - Nut
40 Nm
Always replace if removed
2 - Upper Front Control Arm
3 - Upper Rear Control Arm
4 - Bolt
Always replace if removed
5 - Washer
6 - Wheel Bearing Housing
Removing and installing. Refer to
→ Chapter "Wheel Bear
Navigation Connector Assignment
Information Electronics Control Module 1 -J794-
1 - Not Assigned
2 - Connection block with four multipin connectors
3 - MOST Bus
4 - CVBS input
5 - 4-pin connector (T4al/T4am) for the Front Information
Display Control
