Audi Q5 Owners & Service Manuals

Audi Q5: Storing and recalling settings

Applies to vehicles: with seat memory

Storing settings

  • Adjust the driver's seat.
  • Adjust the two exterior mirrors.
  • Press the [SET] button. The light in the button will come on.
  • Now press a memory button (1 or 2). If the storing procedure is correct, a confirmation tone will sound.

Recalling settings

  • If the driver's door is open and the ignition is switched off, tap the corresponding memory button briefly.
  • If the driver's door is closed or the ignition is switched on, press the appropriate memory button until the stored position is reached.

Successful storage is confirmed audibly and by the light in the [SET] button illuminating > fig. 65.

When the vehicle is locked, the current settings are stored and assigned to the remote control key. But the settings stored on memory buttons 1 to 2 are not deleted. They can be recalled at any time. When the vehicle is unlocked, the settings assigned to the remote control key are restored.

If your vehicle is driven by other persons using your remote control key, you should save your individual seat position on one of the memory buttons.

You can recall your settings again simply and conveniently by pressing the corresponding memory button. When the vehicle is locked, these settings are automatically re-assigned to the remote control key and stored.

WARNING

  • For safety reasons, the seat setting can only be recalled when the vehicle is stationary - otherwise you risk having an accident.
  • In an emergency the recall procedure can be cancelled by pressing the [off] switch or by tapping of the memory buttons.

Activating remote control key memory

Applies to vehicles: with seat memory

To assign the driver's seat settings to the remote control key when locking the vehicle, the function must be activated in the radio or MMI.

  • Select: [car] function button > Seat adjustment > Driver's seat > Key mem. profile > On.

    Or

  • Select: [car] function button > Car systems control button > Vehicle settings > Seats > Driver's seat > Remote control key > On.

Tips

If you do not want another driver's settings to be assigned to the remote control key, switch off the memory function using the radio or MMI or the button.

    READ NEXT:

     Rear seat

    General information Safe transportation of passengers on the rear seats requires proper safety precautions. All passengers on the rear seats must be seated in compliance with the safety guidelines exp

     Head restraints

    Front head restraints Fig. 68 Front seats head restraints: adjusting the height The head restraints on the front seats can be adjusted to provide safe support to head and neck at the optimum height.

     Center armrest

    The armrest is adjustable in several stages and can be moved forward and back. Fig. 71 Armrest between driver's and passenger's seat Adjusting the armrest To adjust the armrest angle, pivot the arm

    SEE MORE:

     Overview - Wheel Bearing

    1 - Nut 40 Nm Always replace if removed 2 - Upper Front Control Arm 3 - Upper Rear Control Arm 4 - Bolt Always replace if removed 5 - Washer 6 - Wheel Bearing Housing Removing and installing. Refer to → Chapter "Wheel Bear

     Center Console Insert, Removing and Installing

    Special tools and workshop equipment required Trim Removal Wedge -3409- Removing - Vehicles with an S tronic transmission: Move the selector lever into "N". - Turn off the ignition. - Remove the Climatronic Control Module -J255-. Refer to → Heating, Ventilation and Air Con

    © 2019-2024 Copyright www.audiq5.net