Audi Q5: Driveshaft
READ NEXT:
Overview - Driveshaft, Mounted On Transmission Side
Note
Pay attention to the general repair information. Refer to
→ Chapter "Repair Information".
The attached driveshaft can only be
Special tools and workshop equipment
required
Transmission Support -VW785/1B-
Counterhold - Kit - Multiple Use -T10172-
Counterhold - Kit - Adapter 5 -T10172/5-
Hose Clip Pliers -VAG1275A-
High
Special tools and workshop equipment
required
Drive Axle Alignment Fixture - 3139-
Counterhold - Kit - Multiple Use -T10172- with Counterhold -
Kit - Adapter 5 - T10172/5-
Engine and Gearbox Jac
SEE MORE:
Procedure
- Free up the wire to be repaired approximately 20 cm on both
sides of the repair point.
Caution
Risk of damaging the electrical wires.
Expose wrapped wiring harnesses carefully.
- If necessary, removing the wiring harness wrapping using a
knife.
- Cut out the dam
Removing
- Remove footwell vent. Refer to
→ Heating, Ventilation and Air Conditioning; Rep. Gr.87; Front
Heater and A/C Unit; Overview - Attachments for Heater and A/C
Unit and Air Intake Housing.
- Disconnect the connector -1- to
the Brake Pedal Position Sensor - G10
