Audi Q5: Technical Data
Transmission/Engine Allocation
Refer to the Parts Catalog for the following information.
- Codes
- Production time period.
- Axle ratio
- Drive Axle flange allocation
- Allocated to the engine, manual transmission and automatic
transmission using the code letters and the PR numbers
Capacities
Capacities, Rear Final Drive 0BC
- Checking gear oil level. Refer to
→ Chapter "Gear Oil, Checking Level".
Capacities, Rear Final Drive 0BD
- Checking gear oil level. Refer to
→ Chapter "Gear Oil, Checking Level".
Capacities, Rear Final Drive 0BF
Caution
Gear oil and ATF fluid change.
- For some RS models the gear oil as well as the ATF
must be changed.
- Refer to
→Maintenance Intervals; Rep. Gr.03 for the
change interval.
- For all other vehicles there is no change interval.
Capacities, Rear Final Drive 0BE
Note
The rear final drive 0BE is only installed with the V8 TDI
engine.
READ NEXT:
1 - Transmission
2 - Driveshaft
Overview. Refer to
→ Chapter "Overview - Driveshaft".
Removing and installing. Refer to
→ Chapter "Driveshaft, Removing and Inst
General Safety Precautions
Pay attention to the following to avoid personal injury and
vehicle damage:
WARNING
Risk of injury and accident by accidentally engaging
a gear with the engine ru
General Repair Information
The highest level of care and cleanliness along with tools
that function properly are required to ensure a proper and
successful transmission repair. Of course the general
SEE MORE:
Sill Panel Strip, Removing and Installing, Front Sill Panel
Special tools and workshop equipment
required
Trim Removal Wedge -3409-
Omega Clip Tool -T40280-, is needed to remove any clips are
that still inside the body.
Removing
- Remove the instrument panel side cover. Refer to
→
1 - Front Seat
2 - Wiring Bracket
Note location
3 - Corrugated Tube Lower Section
Note location
4 - Wiring Harness
Observe notes for routing wiring harness in corrugated tube. Refer
to
→ Chapter "Modular Wire Routing with Corrugated Tube on F