Audi Q5 Owners & Service Manuals

Audi Q5: Selective catalytic reduction

General information

Applies to vehicles: with selective catalytic reduction

In vehicles with selective catalytic reduction, a urea solution (AdBlue) is injected into the exhaust system before a nitrogen oxide catalytic converter to reduce nitrogen emissions.

The AdBlue is carried in a separate tank in the vehicle. The AdBlue usage accounts for approximately 0.5% to 1.2% of the diesel fuel that is used.

When a message about refilling the AdBlue appears in the instrument cluster display, you must refill the AdBlue yourself or have it refilled by an authorized Audi dealer or authorized Audi Service Facility.

Tips

  • The display indicates the distance remaining that can be driven. If the AdBlue tank is completely empty, the engine will not start again after the ignition is switched off.
  • AdBlue is required by law to operate this vehicle.

Messages in the instrument cluster display

Applies to vehicles: with selective catalytic reduction

The display indicates if the AdBlue level is low or if there is a system malfunction.

AdBlue level low

You will be informed if the AdBlue in the tank drops below a certain level.

 Refill AdBlue. See owner's manual

This message appears when there is only enough AdBlue left to drive the distance indicated in the instrument cluster. Fill the AdBlue.

  Refill AdBlue! No restart in 600 mi (1000 km)! See owner's manual

This message appears when there is only enough AdBlue left to drive the distance indicated in the instrument cluster. Fill the AdBlue. Otherwise the engine will not start again if you stop it once the distance indicated has been driven.

  Refill AdBlue! No restart! See owner's manual

This message appears when the AdBlue tank is empty. Fill the AdBlue. Otherwise you will not be able to start the engine again once you stop it.

The AdBlue must be refilled when the amount in the tank has reached the minimum level.

Incorrect filling/system malfunction

A message appears if the AdBlue tank was filled with a fluid other than AdBlue and the system has detected that the tank was filled incorrectly, or if there is a system malfunction.

  AdBlue: Fault! No restart in 600 mi (1000 km)! See owner's manual

This message appears when it is only possible to drive the distance indicated in the instrument cluster. Drive to the nearest authorized Audi dealer or authorized Audi Service Facility to have the malfunction corrected. Otherwise the engine will not start again if you stop it once the distance indicated has been driven.

  AdBlue: System fault. No restart! See owner's manual

This message appears if the system has detected that the tank was filled incorrectly or that there is a malfunction. Drive immediately to the nearest authorized Audi dealer or authorized Audi Service Facility to have the malfunction corrected. Otherwise you will not be able to start the engine again once you stop it.

    READ NEXT:

     Filling AdBlue

    Applies to vehicles: with selective catalytic reduction Fig. 193 Right rear vehicle side: removing the AdBlue cap The AdBlue tank opening is located near the diesel tank opening Add at least 1 gallon

     Refilling AdBlue with a bottle

    Applies to vehicles: with selective catalytic reduction Remove the cap from the refill bottle. Position the bottle on the filler tube and turn the bottle clockwise until it stops turning. Press l

     Checking and Filling

    SEE MORE:

     Door Handle, Removing and Installing

    Removing - Press the door outer seal to the side and remove the protective film over the hole -arrow A-. - Remove the locking bolt -4- as far as the stop using a screwdriver -1-. - Pull the exterior door handle and hold it in the "opened" position. - Press the housing retainin

     Drive Axle Threaded Connection, Loosening and Tightening

    Special tools and workshop equipment required Torque Wrench 80-400Nm -VAG1576- Digital Torque Wrench -VAG1756A- Loosen the threaded connection between the drive axle and wheel hub - With vehicle still standing on its wheels, loosen bolt a maximum of 90º, otherwise wheel bearing will be

    © 2019-2024 Copyright www.audiq5.net