Audi Q5: Electrical Equipment General Information
READ NEXT:
Battery General Information
To guarantee a long service life, the Battery -A- must be
checked, serviced and maintained as described in this manual.
The Battery -A- supplies the power to start the eng
Battery, Checking, Vehicles with Battery Monitoring Control Module J367
or Energy Management Control Module J644 and Data Bus On Board Diagnostic
Interface J533
In certain model series the followi
SEE MORE:
General Information
Only valves and connections that are resistant to
refrigerant R134a and refrigerant oil must be installed.
Different connections (outer diameter) for high pressure and
low pressure side.
Discharge the refrigerant circuit before removing valves or
valve inserts.
Always scr
The flange/driveshaft used before must be installed.
If the flange/driveshaft is also being replaced, do the
following. Refer to
→ Chapter "Flange Shaft Ring, Replacing, 0BD".
Special tools and workshop equipment
required
Puller - Multiple Use -VW391-
Slide Hammer Set -VW771-
Slide
