Audi Q5 Owners & Service Manuals

Audi Q5: Wheel bolts and rims

Audi Q5 Type 8R (2008 - 2017) Owner's Manual / Operating instructions / Wheels / Wheel bolts and rims

Wheel bolts

Wheel bolts must be clean and loosen/tighten easily.

Rims

Rims with a bolted rim ring or with bolted wheel covers consist of multiple pieces. These components were bolted together using special bolts and a special procedure. You must not repair or disassemble them.

WARNING

Wheel bolts that are tightened or repaired incorrectly can become loose and result in loss of vehicle control, which increases the risk of an accident. For the correct tightening specification.

  • Always keep the wheel bolts and the threads in the wheel hub clean and free of grease.
  • Only use wheel bolts that fit the rim.
  • Always have damaged rims repaired by an authorized Audi dealer or authorized repair facility. Never repair or disassemble rims yourself, because this increases the risk of an accident.

Winter tires

Winter tires significantly improve the vehicle's handling when driving in winter conditions. Because of their construction (width, compound, tread pattern), summer tires provide less traction on ice and snow.

  • Use winter tires on all four wheels.
  • Only use winter tires that are approved for your vehicle.
  • Please note that the maximum permitted speed may be lower with winter tires.

    Your authorized Audi dealer or authorized repair facility can inform you about the maximum permitted speed for your tires.

  • Check the tire pressure after installing wheels

The effectiveness of winter tires is reduced greatly when the tread is worn down to a depth of 0.157 inch (4 mm). The characteristics of winter tires also decrease greatly as the tire ages, regardless of the remaining tread.

WARNING

  • Never drive faster than the maximum permitted speed for your tires. This could cause the tires to heat up too much. This increases the risk of an accident because it can cause the tire to burst.
  • Always adapt your driving to the road and traffic conditions. Drive carefully and reduce your speed on icy or slippery roads. Even winter tires can lose traction on black ice.

For the sake of the environment

Reinstall summer tires at the appropriate time, because they provide better handling when roads are free of snow and ice. Summer tires cause less road noise, tire wear and fuel consumption.

Tips

You can also use all season tires instead of winter tires, Please note that in some countries where winter tires are required, only winter tires with the symbol may be permitted.

    READ NEXT:

     Snow chains

    Snow chains improve traction in the snow. Only install snow chains on the rear wheels. Check and correct the seating of the snow chains if necessary after driving a few feet. Follow the instructi

     Uniform tire quality grading

    Tread wear Traction AA А В C Temperature ABC Quality grades can be found where applicable on the tire side wall between tread shoulder and maximum section width > fig. 204. For example: Tre

     Tire pressure monitoring system

    General notes Each tire, including the spare (if provided), should be checked monthly when cold and inflated to the inflation pressure recommended by the vehicle manufacturer on the vehicle placard

    SEE MORE:

     Manual shift program

    Using the manual shift program you can manually select gears. Fig. 137 Center console: shifting the gears manually Fig. 138 Steering wheel: Shift paddles Gear selection with selector lever The tiptronic mode can be selected either with the vehicle stationary or on the move. Push the selector lev

     Tie Rod, Removing and Installing

    Special tools and workshop equipment required Torque Wrench 1332 40-200Nm -VAG1332- Track Rod Tool Insert -T40183- No illustration, commercially available pawl with fine gear Removing - Determine dimension -a- from the center of the wheel to the lower edge of the wheel housing before st

    © 2019-2026 Copyright www.audiq5.net