Audi Q5: Electromechanical power assist, Dynamic
steering
The electromechanical power assist helps the
driver when steering.
Power steering adapts electronically based on
the vehicle speed.
Indicator lights and messages
Steering defective! Do not
drive vehicle!
If this indicator light turns on and stays on and
this message appears, the power steering may
have failed.
Stop the vehicle in a safe location as soon as possible.
Do not continue driving. See your authorized
Audi dealer or other qualified repair facility
for assistance.
Dynamic steering: System
fault! You can
continue driving
If the indicator light turns on and the message
appears, the steering may be more difficult to
move or more sensitive than usual. The steering
may also be at an angle when driving straight.
Drive slowly to your authorized Audi dealer or
qualified workshop to have the malfunction corrected.
Dynamic steering:
Initializing
Audi drive select: if the indicator light blinks and
the driver message appears, the dynamic steering
is reinitialized. After starting the engine, the
steering wheel will move slightly. Re-initialization
might be necessary if the steering wheel was
moved hard to the left and right while the vehicle
was not moving. The display turns off if the initialization
was successful.
Tips
- If the or
indicator light only stays on
for a short time, you may continue driving.
- The dynamic steering stability systems
are not available in the event of
a system malfunction.
- For additional information on dynamic
steering.
READ NEXT:
With all-wheel drive, all four wheels are driven.
General information
With all-wheel drive, power is distributed to all
four wheels. This happens automatically depending
on your driving style and the
Starting ability is optimized
Energy management controls the distribution of electrical energy and thus
optimizes the availability of electrical energy for starting the engine.
If a vehicle with a co
SEE MORE:
Special tools and workshop equipment
required
Torque Wrench 1332 40-200Nm -VAG1332-
Engine and Gearbox Jack -VAS6931- with Universal Support
Plate -VAG1359/2-
Hydraulic Press -VAS6178-
Pneumatic/Hydraulic Foot Pump -VAS6179-
Bearing Installer - Wheel Hub/Bearing Kit -T10205-
Hydraulic Press
Removing
- Remove the outer cover on the rear seat backrest. Refer to
→ Chapter "Outer Cover, Removing and Installing".
- Carefully remove the backrest release handle
-2- from the rear seat.
- Lift the tab on the inside of the backrest release handle
-3- with a small screwdrive