Audi Q5 Owners & Service Manuals

Audi Q5: Adjusting the display and warning tones

Audi Q5 Type 8R (2008 - 2017) Owner's Manual / Operation / Parking system / Adjusting the display and warning tones

Applies to vehicles; with Audi parking system plus with rearview camera

The display and warning tones can be adjusted in the MMI.

  • Select: [car] function button > Parking system.

    Or

  • Select: [car] function button > Car systems control button > Driver assist > Parking aid.

Display

  • Off - when the parking system is switched on, only audible signals are given.
  • On - when the parking system is switched on, either the visual display or the picture from the rearview camera is displayed.

Warning tones

  • Front volume - front sensor volume
  • Front frequency - front sensor frequency
  • Rear volume - rear sensor volume
  • Rear frequency - rear sensor frequency
  • In-car entertainment fader/Music volume while parking - when the parking system is switched on, the volume of the active audio source is lowered.

The newly adjusted value is briefly heard from the signal generator.

Tips

  • The warning tones can also be adjusted directly by the visual display or the picture from the rearview camera. Simply press the Settings control button.
  • Changed settings are activated when parking system is switched on again.
  • The settings are automatically stored and assigned to the remote control key.

    READ NEXT:

     Trailer hitch

    Applies to vehicles: with Audi parking system plus with rearview camera and trailer hitch For vehicles with a factory installed trailer hitch, or a trailer hitch installed according to factory specifi

     Safety

     Driving safety

    SEE MORE:

     Repair a wiring 0.35 mm 2 or greater with intermediate wire section

      Note For the repair use repair wires with a cross section of 0.35 mm2 through 6.0-mm2. Procedure - Free up the wire to be repaired at two places approximately 20 cm on both sides of the repair point.   Caution Risk of damaging the electrical wires. Expose wrapped wiring harness

     Left Seal, Replacing

    Left Seal, Replacing, 0BC In this chapter "right seal, replacing" is also described. The shaft seal can be only be replaced with the final drive removed. Special tools and workshop equipment required Puller - Flanged Shaft -T10037- Bearing/Bushing Installer - Multiple Use -VW295- Seal Inst

    © 2019-2025 Copyright www.audiq5.net